Delta-Q IC650 36 Volt 18 Amp Battery Charger, BASE Unit
* SHIPPING INFORMATION *
The Delta-Q 940-0002 battery charger is a special order item and will ship within 7-10 business days.
The Delta-Q, 940-0002, IC650 is a 36V 18A high performance battery charger capable of charging lead acid (wet/flooded, AGM, Gel) and lithium batteries. Ideal for industrial applications (work platforms, aerial / scissor lifts), floor machines, golf carts, electric vehicles, fork lifts and pallet jacks. The Delta-Q IC650 is equipped with an onboard USB port for to retrieve stored cycle data as well as performing software and charge profile updates.
Features
- Multi-color LED indicator for AC Source, Battery Status, Charging, Error and Fault
- Numeric Display for Charge Profile, Alarm / Fault Codes
- Field Programmable with 25 Charge Profiles
- Auto-Recharge for Low-Voltage in Maintenance Mode
- OEM Customizable
- Field Replaceable Cable design
DC Output
| Maximum DC Output Voltage | 54 Volts |
| Maximum DC Output Current | 18.1 Amps |
| Maximum DC Output Power | 650 Watts |
| Deep Discharge Recovery (Min Voltage) | 1.8 Volts |
| Battery Type | Wet/Flooded, Gel, AGM & Lithium* |
| Reverse Polarity | Electronic Protection with Auto-Reset |
| Short Circuit | Electronic Current Limit |
AC Input
| AC Input Voltage Range | 85 - 270 VAC |
| Nominal AC Input Voltage | 100 - 240 VAC |
| Nominal AC Input Frequency | 50 / 60 Hz |
| Efficiency | 93.5% peak, California Energy Commission Compliant |
|
Safety
|
UL1564, CSA 107.2, EN 60335-2-29, AZ/NZS60335 (RSM) |
| Emissions | FCC Part 15 / ICES003 Class A, EN55011, EN 61000-6-4 |
| Immunity | EN 61000-3-2, EN 61000-3-3, EN 61000-6-2 |
| Dimensions | 9.9" x 7.3" x 3.1” |
| Weight | 5.3 lbs |
| AC Input Connector | IEC320 / C14 (requires country-specific cord)* |
| DC Output Connector | M6 threaded fasteners for ring terminals |
| Mounting Holes | Allows for safe installation on shelf, wall or bulkhead |
| Cooling | Normal operation in any orientation with passive cooling |
| Service Port | Sealed (IP66) USB 2.0 Host Port |
*Delta-Q IC Series battery chargers do not ship with input or output cables/leads; unless stated otherwise. See our Delta-Q Accessories Page for additional components.
| Enclosure | IP66 (NEMA4) |
| Mechanical Shock & Vibration | GMW3172 |
| Operating Temperature | -40° F to 149° F |
| Storage Temperature | -40° F to 185° F |
| Ingress Protection |
Charger rated IP66 (Complete protection against contact, dust, and powerful water jets) with sealed Delta-Q AC cord |
| Chemical | MIL 810-G, Method 504.1: Withstands exposure to chemicals typically found in application (battery acid, salt, cleaners, fertilizers, etc.) |
| Salt | Withstands 720 hours (30 days) salt spray test per GMW 3172 with 5% (w/w) salt solution (pH 6.5-7.2) at 35°C (95°F) without degradation of performance |
| Shock / Vibration |
Infrequent shock: 100g, 11ms half-sine pulse, 3 cycles in each of 3 axes |
| Humidity | 0 to 95% non-condensing |
| Altitude | < 15,000 feet derated above 20° |
| Communication / Signals | |
| Battery Temperature Input | Isolated Temperature Sensor Signals (mates w/Delta-Q isolated battery temperature sensors) |
| Charge Enable / Disable Input | Not Available |
| Interlock Signal | Standard (Battery positive signal when AC not present) |
| Remote Status Indicator | Not Available |
| CANbus | Not Available |
| Serial Communications | Not Available |
Signal Connector
6.3mm (1/4") Blade Terminals
- C1 - Battery Temperature Sensor (Negative / - )
- C1 - Battery Temperature Sensor (Positive / + )
- C3 - Interlock Signal
| Part Number | 940-0002 |
|---|---|
| MPN | 940-0002 |
| Charger Mode | Automatic |
| Charger Type | On-Board |
| DC Cord Length | NOT INCLUDED |
| Dimensions | 9.9" x 7.3" x 3.1" |
| Amp Output | 18 Amp |
| Output Voltage | 36 Volt |
| Input Voltage | 120 Volts, 240 Volts |
| Charger Efficiency | 93% |
| Charger Application | Golf Cart, Industrial |
| CEC Compliant | Yes |
| COMM Port | No |
| Temperature Sensor | No |
| Interlock | No |
| Remote LED | No |
