Group Size 24-31 Adjustable Plastic Marine Battery Box

$15.50
Part Number
120173
  • Buy 2 for $14.73 each and save 5%

Durable - Affordable - Reliable - Secure

The Group Size 24-31 Adjustable Battery Box is typically found in marine and recreational applications for securing and protecting starting and deep cycle group size 24, 27 and 31 batteries. Paired with a locking lid and battery box strap this box will prevent accidental shorts and keep the battery in its place while you're on the water. With mounting holes built into the box's handles it can easily accept J or L type bolts for securing the box while still being able to remove the cover. Our Adjustable Battery box will effectively collect battery acid preventing damage to your boat and surrounding parts and equipment.

Made in the USA

QuickLock Cover

  • Easy-on and Easy-off
  • Safe and Secure
  • Convenient, Fast and Durable
  • Locking feature prevents cover loss

Tougher Material

  • Impervious to acid, gasoline,oil, solvents
  • Impact resistant to -30°F (-34°C)
  • Heat stable to 200°F (93°C)
  • UV Protected
  • Meets U.S. Coast Guard Regulations 183.420 & ABYCE-10.7

Mounting Holes

  • Use hold-down holes molded in to reinforced handles
  • For use with J-Bolts or L-Bolts
  • Remove lid while keeping the box secure

Includes

  • Battery Box Strap and Hardware
More Information
Part Number 120173
MPN 120173-001
UPC 0 17378 10249 6
Battery Group Size Group Size 24-31
Box Material Plastic
Box Configuration 1 Battery
Inside Dimensions
Length 14-1/2"
Width 7-1/4"
Height 10-3/8"
Outside Dimensions
Length 17-3/4"
Width 10-1/4"
Height 10-7/8"
Write Your Own Review
You're reviewing:Group Size 24-31 Adjustable Plastic Marine Battery Box
Your Rating
Enter your shipping information below to receive a shipping estimate. Note: The shipping estimate calculates for one of these products. To calculate shipping for more than one add your desired quantity to your shopping cart.
Customer Questions
No Questions
Did you find what you were looking for?
Storage batteries in boats

Did you know that the United States Coast Guard has regulations regarding batteries? Properly Installing one of our battery boxes will meet USCG federal regulations.

Here are the regulations directly from 33 CFR 183.401-460 

  • Each installed battery must not move more than one inch in any direction when a pulling force of 90 pounds or twice the battery weight, whichever is less, is applied through the center of gravity of the battery as follows:
  • Vertically for a duration of one minute.
  • Horizontally and parallel to the boat's center line for a duration of one minute fore and one minute aft.
  • Horizontally and perpendicular to the boat's center line for a duration of one minute to starboard and one minute to port.
  • Each battery must be installed so that metallic objects cannot come in contact with the ungrounded battery terminals.
  • Each metallic fuel line and fuel system component within 12 inches and above the horizontal plane of the battery top surface as installed must be shielded with dielectric material.
  • Each battery must not be directly above or below a fuel tank, fuel filter, or fitting in a fuel line.
  • A vent system or other means must be provided to permit the discharge from the boat of hydrogen gas released by the battery.
  • Each battery terminal connector must not depend on spring tension for its mechanical connection to the terminal.

In our home state of Wisconsin our regulations regarding batteries are as follows:

It is unlawful to operate a motorized vessel equipped with a storage battery unless the battery is secured against shifting. A covered battery box with strap is best. In addition, the battery must be equipped with nonconductive terminal shields to prevent accidental shorting. Both the positive and negative terminals must be covered.

Many States have similar regulations. If your State does not have any boating rules regarding storage batteries it is recommended to follow USGC regulations.

Storage Batteries in Boats

Did you know that the United States Coast Guard has regulations regarding batteries? Properly installing one of our battery boxes will meet USCG federal regulations.

Here are the regulations directly from 33 CFR 183.401-460

Each installed battery must not move more than one inch in any direction when a pulling force of 90 pounds or twice the battery weight, whichever is less, is applied through the center of gravity of the battery as follows:

  • Vertically for a duration of one minute.
  • Horizontally and parallel to the boat's center line for a duration of one minute fore and one minute aft.
  • Horizontally and perpendicular to the boat's center line for a duration of one minute to starboard and one minute to port.
  • Each battery must be installed so that metallic objects cannot come in contact with the ungrounded battery terminals.
  • Each metallic fuel line and fuel system component within 12 inches and above the horizontal plane of the battery top surface as installed must be shielded with dielectric material.
  • Each battery must not be directly above or below a fuel tank, fuel filter, or fitting in a fuel line.
  • A vent system or other means must be provided to permit the discharge from the boat of hydrogen gas released by the battery.
  • Each battery terminal connector must not depend on spring tension for its mechanical connection to the terminal.

In our home state of Wisconsin, our regulations regarding batteries are as follows:

It is unlawful to operate a motorized vessel equipped with a storage battery unless the battery is secured against shifting. A covered battery box with strap is best. In addition, the battery must be equipped with non-conductive terminal shields to prevent accidental shorting. Both the positive and negative terminals must be covered.

Many States have similar regulations. If your State does not have any boating rules regarding storage batteries, it is recommended to follow USCG regulations.

More products by Quick Cable