Delta-Q IC900 36 Volt 25 Amp Battery Charger, BASE Unit
* SHIPPING INFORMATION *
The Delta-Q 942-0002 battery charger is a special order item and will ship within 2-3 weeks.
The Delta-Q, 942-0002, IC900 is a 36V 25A high frequency battery charger capable of charging lead acid (wet/flooded, AGM, Gel) and lithium batteries. Ideal for industrial applications (work platforms, aerial / scissor lifts), floor machines, golf carts, electric vehicles, fork lifts and pallet jacks. The Delta-Q IC900 is equipped with an onboard USB port for to retrieve stored cycle data as well as performing software and charge profile updates.
Features
- Multi-color LED indicator for AC Source, Battery Status, Charging, Error and Fault
- Numeric Display for Charge Profile, Alarm / Fault Codes
- Field Programmable with 25 Charge Profiles
- Auto-Recharge for Low-Voltage in Maintenance Mode
- OEM Customizable
- Field Replaceable Cable design
DC Output
Maximum DC Output Voltage
|
54 Volts
|
Maximum DC Output Current
|
25.0 Amps
|
Maximum DC Output Power
|
900 Watts
|
Deep Discharge Recovery (Min Voltage)
|
1.8 Volts
|
Battery Type
|
Wet/Flooded, Gel, AGM & Lithium*
|
Reverse Polarity
|
Electronic Protection with Auto-Reset
|
Short Circuit
|
Electronic Current Limit
|
AC Input
AC Input Voltage Range | 85 - 270 VAC |
Nominal AC Input Voltage | 100 - 240 VAC |
Nominal AC Input Frequency | 50 / 60 Hz |
Efficiency
|
90% at full load, 120VAC, 48VDC / 92% at full load, 240VAC - California Energy Commission (CEC) Compliant Pending
|
Safety
|
UL1564, CSA 107.2, EN 60335-2-29, AZ/NZS60335 (RSM)
|
Emissions
|
FCC Part 15 / ICES003 Class A, EN55011, EN 61000-6-4
|
Immunity
|
EN 61000-3-2, EN 61000-3-3, EN 61000-6-2
|
Dimensions | 13.2" x 7.0" x 4.0” |
Weight | 9.6 lbs |
AC Input Connector | IEC320 / C14 (requires country-specific cord)* |
DC Output Connector | M6 threaded fasteners for ring terminals |
Mounting Holes | Allows for safe installation on shelf, wall or bulkhead |
Cooling | Normal operation in any orientation with passive cooling |
Service Port | Sealed (IP66) USB 2.0 Host Port |
*Delta-Q IC Series battery chargers do not ship with input or output cables/leads; unless stated otherwise. See our Delta-Q Accessories Page for additional components.
Enclosure | IP66 (NEMA4) |
Mechanical Shock & Vibration | GMW3172 |
Operating Temperature | -40° F to 149° F |
Storage Temperature | -40° F to 185° F |
Ingress Protection |
Charger rated IP66 (Complete protection against contact, dust, and powerful water jets) with sealed Delta-Q AC cord |
Chemical | MIL 810-G, Method 504.1: Withstands exposure to chemicals typically found in application (battery acid, salt, cleaners, fertilizers, etc.) |
Salt | Withstands 720 hours (30 days) salt spray test per GMW 3172 with 5% (w/w) salt solution (pH 6.5-7.2) at 35°C (95°F) without degradation of performance |
Shock / Vibration |
Infrequent shock: 100g, 11ms half-sine pulse, 3 cycles in each of 3 axes |
Humidity | 0 to 95% non-condensing |
Altitude | < 15,000 feet derated above 20° |
Communication / Signals | |
Battery Temperature Input | Isolated Temperature Sensor Signals (mates w/Delta-Q isolated battery temperature sensors) |
Charge Enable / Disable Input | Not Available |
Interlock Signal | Standard (Battery positive signal when AC not present) |
Remote Status Indicator | Not Available |
CANbus | Not Available |
Serial Communications | Not Available |
Signal Connector
6.3mm (1/4") Blade Terminals
- C1 - Battery Temperature Sensor (Negative / - )
- C1 - Battery Temperature Sensor (Positive / + )
- C3 - Interlock Signal
Part Number | 942-0002 |
---|---|
MPN | 942-0002 |
Charger Mode | Automatic |
Charger Type | On-Board |
DC Cord Length | NOT INCLUDED |
Dimensions | 13.2" x 7.0" x 4.0" |
Amp Output | 25 Amp |
Output Voltage | 36 Volt |
Input Voltage | 120 Volts, 240 Volts |
Charger Efficiency | 90% / 92% |
Charger Application | Golf Cart, Industrial |
CEC Compliant | Pending |
COMM Port | No |
Temperature Sensor | No |
Interlock | No |
Remote LED | No |